AEG DDLE EASY Electronic Instantaneous Water Heater, 24 kW, White

Hot water convenience: Instant and unlimited hot water for the bathroom, kitchen and more. Constant temperature: presets for shower (42°C) and kitchen (55°C). Easy to assemble: Flexible above or below table assembly possible. Economical: Low line losses and energy saving. Are you looking for a reliable and convenient hot water solution for your home? Then the AEG DDLE EASY electronic instantaneous water heater is just right for you! With this device you benefit from instant and unlimited hot water at one or more points, whether at the washbasin, in the shower, in the kitchen sink or in the bathtub. High comfort, easy operation The DDLE EASY offers you the highest temperature comfort. Thanks to the preset application icons, you can easily select the desired temperature for the shower (42°C) or kitchen sink (55°C). The fast control electronics ensure a largely constant water temperature so that you can always rely on your hot water. Uncomplicated installation Installing the instantaneous water heater is extremely easy. It can be mounted above or below the table, depending on what suits your space best. Note that a pressure connection (closed fitting), as well as a permanent connection and a cold water connection are required. Economical and efficient The DDLE EASY is not only comfortable, but also economical to use. Thanks to the short cable routes, there are hardly any cable losses. Robust technology The instantaneous water heater has a bare wire heating system that is insensitive to calcification and ensures a long service life. The IP25 water jet protection offers additional safety. Note: A 400 V power connection (three-phase alternating connection) is required to install this device. The assembly (water and electrical installation) as well as the initial commissioning and maintenance of this device may only be carried out by a qualified electrician in accordance with the applicable regulations and in accordance with these instructions. A three-phase AC connection (high power connection) is required to operate this device. For devices with a nominal output of more than 12kW, the consent of the respective network operator must be available or obtained before initial installation. The device may only be installed with the consent of the network operator by the network operator itself or by an installation company that is registered in the installer directory of a network operator.